Home » PT Model 15mm Type 1 Composite Control Horn Set – Fiberglass (10 Pack)
PT Model Composite Control Horn, Type 1, 15mm
PT Model Type 3 Composite Control Horn – 1.5" (38mm) Fiberglass (5 Pack)
PT Model Composite Control Horn, Type 1, 15mm
PT Model Composite Control Horn, Type 1, 15mm
PT Model Type 3 Composite Control Horn – 1.5" (38mm) Fiberglass (5 Pack)
PT Model Composite Control Horn, Type 1, 15mm
PT Model

PT Model 15mm Type 1 Composite Control Horn Set – Fiberglass (10 Pack)

In stock
SKU: PT-CH-1
(1)
$3.30

PT Model Type 1 Composite Control Horn – Fiberglass (5 Pack)

The PT Model Type 1 Composite Control Horn is a lightweight fiberglass control horn designed for straight, direct linkage setups. This standard geometry horn provides clean pushrod alignment and predictable control surface response, making it ideal for a wide range of RC airplane builds.

Type 1 control horns are best used when the servo and control surface are already aligned, allowing for a simple, efficient linkage with minimal complexity.

Best For: Straight linkage setups where the servo and control surface are properly aligned.

Key Features

  • Straight geometry design for direct, linear pushrod alignment
  • Fiberglass composite construction – lightweight and rigid
  • Clean, low-profile installation
  • Consistent and predictable control response
  • Ideal for sport, pattern, and general RC aircraft builds
  • 5 control horns per pack

Specifications

Brand PT Model
Type Type 1 (Straight Geometry)
Material Fiberglass Composite
Quantity 5 Control Horns

Why Choose Type 1?

  • Ideal for straight pushrod installations
  • Provides direct, predictable control response
  • Simple, clean geometry with minimal linkage complexity
  • Works well in most standard sport and pattern aircraft setups

Installation Diagram

Basic RC Linkage Layout
Servo Arm
→
Pushrod / Clevis
→
Type 1 Horn
→
Control Surface

For best results, align the linkage hole as close as possible with the hinge line to ensure smooth and efficient control movement.

Installation Guide

  1. Mark horn position: Align the horn with the hinge line
  2. Check alignment: Ensure pushrod runs straight from servo to horn
  3. Prepare surface: Lightly sand bonding area if needed
  4. Test fit: Confirm proper positioning before gluing
  5. Bond securely: Use epoxy for a strong installation
  6. Attach linkage: Install pushrod, clevis, or ball link
  7. Test movement: Verify smooth, bind-free operation
Modeler’s Tip: Use Type 1 control horns when your linkage is already properly aligned. This provides the most direct and efficient control response with minimal setup complexity.

Control Horn Type Guide (Type 1 vs Type 2 vs Type 3)

Not sure which control horn you need? Use the guide below to choose the correct geometry for your setup.

Type Shape Best Use When to Use
Type 1 Straight Direct linkage setups Servo and control surface are already aligned
Type 2 Curved Smooth linkage angles Pushrod is slightly off-angle
Type 3 Offset / Stepped Alignment correction Servo and surface are not in line
Quick Selection Tip:

• Straight setup → Type 1
• Slight angle → Type 2
• Offset / tight geometry → Type 3

Package Includes

  • 5 × PT Model Type 1 composite control horns

Required to Complete

  • Pushrods, clevises, or ball links
  • Epoxy adhesive
  • Basic hobby tools